214 / 336
11/14
Total Solution to Earthing & Lightning Protection |
9AKK106354A3360
11
Mains power protection
ESP M1 Series
Combined Type 1, 2 and 3 tested protector (to BS EN 61643) for use on mains
power distribution systems primarily to protect connected electronic equipment
from transient overvoltages on the mains supply, e.g. computer, communications
or control equipment. For use at boundaries up to LPZ
0
to protect against
flashover (typically the main distribution board location, with multiple metallic
services entering) through to LPZ 3 to protect sensitive electronic equipment.
Installation
Install in parallel, within the power distribution board or
directly (via fuses) on to the supply feeding equipment.
At distribution boards, the protector can be installed
either on the load side of the incoming isolator, or on
the closest outgoing way to the incoming supply. Connect,
with very short connecting leads, to phase(s), neutral and
earth. For TT installations, contact Furse.
Accessories
Weatherproof enclosures:
WBX 3
Use with single phase protectors
WBX 4
Use with three phase protectors
Full product range order codes can be
found on pages 17/8-17/9
NOTE:
If you desire a protector with an extra high maximum surge current use the ESP M2 or ESP M4 series. If your supply is fused at 16 amps, or less,
the in-line protectors (ESP 240 or 120-5A (or -16A) and their ready-boxed derivatives) may be more suitable. If you need to mount the display panel
separately from the main protector unit, use the ESP M1R series.
Parallel connection of
single phase protectors ESP 240
M1, ESP 120 M1 or ESP 277 M1
(fuses not shown for clarity)
Parallel connectionof
ESP 415 M1, ESP 208 M1
or ESP 480 M1 to three
phase star (4 wire and
earth) supplies (fuses not
shown for clarity)
DIRTY
CLEAN
To
load
From
supply
DIRTY
CLEAN
To
load
From
supply
Features & benefits
–– Very low let-through voltage (enhanced protection to
IEC/BS EN 62305) between all sets of conductors (phase
to neutral, phase to earth, neutral to earth - Full Mode
protection)
–– Full mode design capable of handling partial lightning
currents as well as allowing continual operation of
protected equipment
–– Repeated protection in lightning intense environments
–– Innovative multiple thermal disconnect technology for safe
disconnection from faulty or abnormal supplies (without
compromising protective performance)
–– Three way visual indication of protection status and advanced
pre-failure warning so you need never be unprotected
–– Remote indication facility allows pre-failure warning to be
linked to a building management system, buzzer or light
–– Changeover active volt-free contact enables the protector
to be used to warn of phase loss (i.e. power failure,
blown fuses etc)
–– Flashing warning of potentially fatal neutral to earth
supply faults (due to incorrect earthing, wiring errors or
unbalanced conditions)
–– Robust steel housing
–– Base provides ultra-low inductance earth bond to
metal panels
–– Compact size for installation in the power distribution board
–– ESP 120 M1 and ESP 240 M1 have Network Rail Approval
PA05/02700 and PA05/01832 respectively. NRS PADS
reference 086/000556 (ESP 120 M1) and 086/047149
(ESP 240 M1)