10 / 40
10
Lighting Control Catalogue
LON I/OModules
Lighting Control Solutions cover a wide range of functions, including
•
Digital Inputs for 24 V and 230 V input voltage, and for floating contacts
•
Analog inputs and outputs
•
Switching actuators with 24 V semiconductor outputs
•
Switching actuators with relay outputs
•
Phase controlled dimmers 1-10 V control devices for dimmable electronic ballasts
•
LON DALI-Controllers for control of electronic DALI components
Most of the devices are suitable for DIN rail mounting. These devices are sub-classified into the three product lines M, N and S.
Cables can be attached to the inputs and outputs of most devices in the M, N, and S product range by use of pluggable screw-type
terminals. They can be quickly and easily replaced when the need arises.
This provides protection against polarity reversal – should the device be replaced – and against accidental contact at
any time.
Clamp-type terminals allow up to four bus cables to be connected to the device, so that the line is not interrupted if a device is
disconnected from the network.
Power lines and bus cables may be installed without spacing. Single insu-lated wires or power lines and bus cables either have to
be installed with a spacing of 4 mm or they need an appropriate insulation (DIN VDE 01 10-1). A protective cap is included with the
REG-M and REG-N modules, by means of which which a clear separation of power line and bus cable is guaranteed.
The “DR-N” product line is the latest generation of I/O modules with the following features:
•
Bus connection via 2-pin bus terminal with protective cap
•
Pluggable screw-type terminals for inputs and outputs
•
Status LED for every input and output
•
Manual operation
•
Free-Topology-Transceiver (FTT)
•
DC 18...30 V supply voltage
•
Configurable reaction of the outputs to power-down and power-up/reset
The ”DR-M” product line consists of about 20 I/O modules with the following distinctive features:
•
Bus connection via 2-pin bus terminal with protective cap
•
Pluggable screw-type terminals for inputs and outputs
•
Link Power Transceiver (LPT)