158 / 180
158
Technical
information
Connect
Requirements
n
With new radio systems the push-button, on which a receiver is firstly programmed, manages the system administration. The system
administrator is installed last of all as you will need to be able to move it near the devices which are to be programmed.
n
Install all devices, except for the system administrator, at their final installation locations and connect them.
Connect the loads to the receivers. Some receivers use the load to display confirmation of commands received during the learning process.
Teaching devices
Connections between devices are established by first teaching all receivers individually to the system administrator.
Subsequently, additional transmitters are taught to the system administrator. During this procedure the connections and functions of the
system administrator are copied to the transmitters. That means the transmitters carry out the same functions as the system administrator.
The teaching process
Only three steps are necessary to carry out teaching. Basic procedure:
1
Move the (prospective) system administrator into the vicinity of the device which is to be taught.
2
First of all press the key on the (prospective) system administrator three times within approximately 1.5 seconds.
- If a system administrator does not yet exist, the LED will start to flash for approximately 6 seconds and then will light up continuously for
approximately 30 seconds.
- If a system administrator exists already, the LED will immediately light up for 30 seconds.
You have time to teach a different device during the 30-second period when the LED lights up continuously.
3
Press the key/programming button/sensor surface on the device to be taught three times within approximately 1.5 seconds. This is
confirmed by the LED lighting up for approximately 1 second.
The system administrator and the device which was to be taught are now connected with each other. If you want to teach additional devices,
repeat the three steps.
Example:
Installation of a two-way circuit with two receivers:
1
2
3x
3x
1
2
+
6 s 30 s
Step 1: Teach receiver 2 to the system administrator.
3 +
1
2
3x
3x
1
3
30 s
Step 2: Teach receiver 3 to the system administrator.
3x
4
3
+
1
2
3x
1
4
30 s
Step 3: Teach transmitter 4 to the system administrator
1
2
3
4
1
1
2
2
3
3
4
4
Result:
You have installed a two-way circuit with
two transmitters (push-buttons) and two loads.
Easy Connect