24 / 44
24
klik • Technical
5mm
40mm
5mm
2mm
1. Strip cable as above -
Note: Trim cable tails to
double over for better
terminal contact.
2. Remove plug cover.
3. Pass cable through plug cover
centre hole.
4. Terminate conductors into
terminals.
5. Push outer sheath of cable
firmly into jaws of sheath grip,
making sure that at least 2mm
of sheath protrudes below the
grip.
6. Refit cover.
klik 4 pin
Installation
klik Mounting Box Installation
Cable entry through spout in base of box for maximum wiring space.
MB2 knockouts in base and sides. Supplied with M4 x 20mm long
fixing screws.
MB3/E is dual purpose box for flush mounting in solid or partition
walls. Provided with mounting wings for partition use. Supplied with
M3.5 x 20mm long fixing screws. Cable entry in one end.
Flush Mounting for Solid Walls
Flush Mountings for Partition Walls
The mounting wings act as a flange, stopping the box from being
pulled out of the partition.
Cat No. S21
Cat No. MB3/E
less wings
Cat No. MB3/E
Mounting Methods
• Hanging from ceiling
suspension system with
Caddy Clips™
• Direct fixing to lighting
trunking
• Direct fixing to ceiling or wall
with No. 8 screws
Drop rods on sides
Screw to surface
Drop rods on rear
Top
Rear
Bottom