23 / 210
23
Standard individual
check sheet
in accordance with the IEC 61439-1
and 2 standard from the assembly
manufacturer (panelbuilder)
Job No.: .................................................................................................
Switchboard No.: ...................................................................................
Drawing No./Rev. No.: ............................................................................
Chapter
Verified
Degrees of protection provided by enclosures
11.2
Insulation clearances and creepage distances
11.3
Protection against electric shocks and integrity
of protection circuits
11.4
Integration of incorporated components
11.5
Internal electric circuits and connections
11.6
Terminals for external conductors
11.7
Mechanical operation
11.8
Dielectric properties
11.9
Wiring, operating performance and function
11.10
Date of verification:
............ / ............ /.............
Verifications performed by:
..........................................................................…………………………
IEC 61439-1 paragraph 11.6
Internal electric circuits
and connections
Schneider Electric recommends marking
the nut with a tinted acrylic lacquer, indelible
and temperature-resistant.
This allows:
>
not only self-checking to check effective
tightening to torque;
>
but also identification of any loosening.
IEC 61439-1 paragraphe 11.9
Dielectric properties
The main circuits, and the auxiliary and
control circuits connected to the main circuit,
shall be subjected to the test voltage in
accordance.
IEC 61439-1 paragraph 11.10
Wiring, operating performance
and function
Verification of wiring and marking conformity
with the drawings, parts list and diagram.
IEC 61439-1 paragraph 11.4
Protection against electric shocks
and integrity of protection circuits
The following should be checked visually:
>
presence of protective shields against
direct and indirect contacts on live parts;
>
presence of the PE conductor.
The continuity of protection circuits is
ensured by compliance with the assembly
instructions delivered with each product.
IEC 61439-1 paragraph 11.5
Integration of incorporated
components
The assembly manufacturer must comply
with the instructions of the original equipment
manufacturer for installation
and wiring of the components used.