60 / 80
60
klik catalogue 2012 • klik.system project
Increasing
your control
klik.system is designed to give you the control you require for lighting in your building, this ensures that
the minimum amount of energy is used, also allowing people to use the building in comfort and safety.
klik.systems’ unique plug and play connector allows re-configuration
of the building lighting distribution and control as the needs and use
of the building change.
Where large offices are required to be sub-divided into smaller offices
or vice versa, the klik.system can be simply re-configured with the
addition of plug-in sensors, switches or control circuits linked as
required.
Upgrading of luminaires from on/off HF to Digital can also be catered
for by a simple change to the pre-wired lead and sensor without the
need to make changes to the Lighting Marshalling Boxes. To reduce
disruption during maintenance periods the pre-wired leads can be
disconnected on load.
klik.system also allows flexible configuration at commissioning where
areas can be linked together. This is important in larger open plan
areas where specification requires notional or actual corridors to be lit
if any part of the area is occupied.
Building-wide common zones such as lift lobbies, stairways or break
out areas can also be controlled so that the lighting is on whenever
the building is occupied.
klik.system offers a comprehensive range of energy saving lighting
control and distribution products to meet all requirements for a lower
cost of ownership through increased energy efficiency and reduced
maintenance requirements.
This system encompasses innovative cost-effective solutions,
providing a fast payback for every area of the building, from the
restrooms to large open plan offices.
Basic manual system
Standard automatic system
Dimming connection system
Complete building system
klik.system allows for a variety of control philosophies:
For manual switching using pluggable switch drops for fast
installation and reconfiguration if required.
This employs state of the art plug-in presence detectors complete
with photocell technology. Automatically saving energy when areas
are not occupied by switching lighting off, and not switching lighting
on when sufficient natural daylight is available. Absence detection
enables even more control and therefore energy savings.
This system uses our 5 and 6 core pre-wired plugs & sockets,
enabling data from digital dimming detectors to control lighting.
Using this system the lighting can be configured to the exact level
required by the occupants of an area. The system takes into account
the amount of available natural light and uses the minimum amount of
power to raise the light level to the required lux.
Using klik.system alongside our tebis.TX we can implement a
whole building system of control and wiring. With the use of KNX,
a European building control standard, klik.system and tebis.TX can
integrate lighting control with all other building services.