102 / 164
102
WIRING ACCESSORIES AND SINGLE PHASE DISTRIBUTION
PG00400018U – March 2012
xComfort system overview
Basic mode components
10.3
RF PIR Motion sensor
This PIR motion sensor is designed to sense movement inside a building. Power supply is provided either through
two AAA-batteries (included in the scope of delivery) or through a power supply unit (CMMZ – 00/08), not included
in the scope of delivery), therefore it is easy to fix (screw or glue) it wherever you need it. To make it easy for you
to do setting, we provide an adjustable “mounting support” (CMMZ – 00/09). Channel A (for lighting) transmits
a switching command depending on the movement that has been detected, on the brightness and on the time-
setting for the light to shut off again. Channel B (for alarm functions) transmits a switching command when
movement is detected, irrespective of brightness and time-setting for switch-off (channel B is activated for approx.
145 seconds). The setting for the number of impulses to be analysed before triggering an alarm or transmitting a
switching command can be done for both channels at the same time. All the settings can be carried out directly on
the device, with the front cover removed. A light emitting diode (LED) makes the job of setting the sensor easier.
Description
Eaton list
number
110°, covers 12m when mounted at a height of h=2.2m
CBMA-02/01
CBMA-02/01
Mounting set for the motion sensor
The mounting set for the motion sensor is used where the sensor needs to be adjusted to different directions in
order to guarantee an optimal area covered by the motion sensor (CBMA-02/01). (Two fixing screws are included).
Description
Colour
Eaton list
number
Mounting set
white
CMMZ-00/09
CMMZ-00/09
RF binary input unit 2 x 230VAC
The binary input unit transmits input signals e.g. from window contacts, motion sensors or other signal contacts
(relays, switches, pushbutton units, etc.) to the xComfort installation system. Power supply is from the mains.
The device can be mounted in installation boxes for switches, branch-off boxes or standard installation boxes.
Description
Eaton list
number
2 x 230VAC
CBEU-02/01
CBEU-02/01
12-channel remote control
The 12-channel remote control sends signals to xComfort system when it is operated. This mobile device is powered
by two AAA batteries. The functions can be individually assigned, with no distinction to be made between blinds
control, dimming, switching etc. Pushing the pre-selection key (1-6) once will take you to level 1 (channels 1 to 6),
(short) pushing the pre-selection key (1-6) twice will take you to level 2 (channel 7-12). The two LEDs indicate the
level and whether the signal has actually be sent, correctly interpreted and re-confirmed. Optionally, wall-mounting
via a magnet is possible too (CMMZ-00/11 – to be ordered separately). Battery included in the scope of delivery.
Description
Eaton list
number
12 channels
CHSZ-12/03
CHSZ-12/03
2-channel remote control
The 2-channel remote control sends signals to the xComfort system when it is operated. This mobile
device is powered by a coin cell battery (CR2430). The functions can be individually assigned, with no
distinction to be made between blinds control, dimming, switching etc. A LED indicates whether the
signal has actually been sent, correctly interpreted and re-confirmed. The remote control can simply
be fixed at the key ring (included in the scope of delivery). Optionally, wall-mounting via a magnet is
possible too (CMMZ-00/11 - to be ordered separately). Battery included in the scope of delivery.
Description
Eaton list
number
2 channels (mini)
CHSZ-02/02
CHSZ-02/02